CALIBERVR CLAY MONSTER V1 Premium Weight Kit

Match the weight of your actual shotgun for the ultimate training experience in VR. The weight kit consists of:

• Internal foregrip weight kit that fits in two 1/2 bores within the factory foregrip. You can add up to 16 oz with this kit in .67 oz increments. This is perfect if you want a little more weight but want to reduce strain for extended sessions. 

• Barrel cap weight box (orange) which allows you to add up to 8oz to factory barrel cap

• Rib weight box which allows you to add up to 5oz to the rib on the top of the barrel. 

• Bottom rail weight box and adjustable clamp which allows it to be placed anywhere on the lower rail between the grip and front upright. The box holds up to 11oz. 

• Two end cap weight boxes that can be installed above and below the upright clamps utilizing threaded ends of the extrusion. Each box can hold up to 4 oz.

• One rear weight box which bolt to the back of the extrusion at the buttstock end utilizing the threaded end of the lower extrusion. Up to 4 oz can be utilized here as well. 

• 36 x 1 oz individual iron weights. (If all boxes are filled to capacity, you will utilize all 36 of the weights)

• If both the internal foregrip, and external weight boxes are utilized at full capacity, this adds 3.25 pounds in weight to the stock which is approximately 4.5 lbs. This brings total weight to 7.75lbs which is in the range of typical semi-auto, over-under, or single barrel trap shotguns typically used for clay sports. An ultra-heavy kit is in the works, but this kit will fit the needs of most shooters out there.